Jump to main content

Appliance repair across Greater Houston

LG logo

LG appliance service in Greater Houston homes.

An LG refrigerator that stops cooling may have a fault in the linear compressor, its inverter board or the main board. We test the board before condemning the sealed system, then price the repair once.
  • Fault found before any price
  • One fixed price you approve
  • 90-day parts warranty

Free to request · 3 steps

Request a repair appointment

Takes about a minute. There is no charge to submit a request.

Prefer to call?(832) 476-8009
Step 1 of 3: Appliance and fault

Appliance and fault

01Which appliance needs attention?
02What is it doing?Select an appliance first and its common faults will appear here.
Diagnosis
The cause is identified before any price is given
Approval
One fixed price, and work begins only with your consent
Hours
Our phones are answered 24 hours a day
Warranty
Parts warranted for 90 days, labor for 30

Mass Market

LG appliances our technicians service

Common LG failure points

  • Linear compressor faults that also involve the inverter board
  • Direct Drive washer noise from a worn stator or loosened rotor bolt
  • Rear drum bearing noise during spin
  • Defrost faults letting the evaporator ice over
  • Blocked drain pump stopping the spin

Error codes

LG error codes explained

LG codes, grouped by appliance. A code shows where testing starts, not which part failed; we check it on your unit first.

  • InstaView and Door-in-Door fridges
  • ThinQ laundry
  • WashTower
  • QuadWash dishwashers
  • Fridges with Inverter Linear compressors

LG washer

IE
The washer did not fill within the expected time. Check the supply tap, the inlet screens and the water inlet valve.
OE
The washer cannot drain. Inspect the pump filter first, then the drain hose, and finally the drain pump itself.
UE
The washer was unable to redistribute an unbalanced load.
dE / dE1 / dE2
The door is either failing to lock or is not being detected as closed.
LE
The motor is overloaded or locked. An object lodged in the drum can cause this, as can a failed motor or a faulty position sensor.
tE
A fault with the heater or with the sensor that measures water temperature.
FE
The washer has overfilled, either because the inlet valve is not closing or because the pressure sensor is faulty.
PE
The pressure sensor that measures water level has a fault.

LG dryer

d80 / d90 / d95
The dryer estimates that its vent is restricted by 80, 90 or 95 percent. The full length of the vent should be cleaned.
tE1 / tE2
The thermistor at the exhaust or at the heater is reading as an open or short circuit.
PS
A supply fault, in which one leg of the 240V circuit is not reaching the dryer.

LG refrigerator

Er IF
A fault with the ice maker fan, frequently caused by ice forming around the fan.
Er FF
A freezer fan fault, usually the result of frost accumulating on the evaporator coil.
Er dH
The defrost heater circuit has a fault.
Er CF
A fault has been detected in the condenser fan.
Er CO
Communication between the display board and the main control board has been lost.

LG dishwasher

OE
The dishwasher cannot drain. Check the filter, the sink air gap, the knockout plug in the disposer and the drain pump.
IE
The dishwasher is not filling. Confirm that the water supply valve is open and that the inlet is unobstructed.
AE
The sensor in the base has detected a leak.
HE
A fault in the heater or in its circuit.

Safe checks to make before calling

  • • A dryer showing d80, d90 or d95 is reporting a restricted vent rather than a fault in the machine. Arrange for the vent run to be cleaned.
  • • If the washer will not drain, open the small access door at the lower front; the pump filter is located behind it.
  • • If OE appears soon after a new garbage disposer was fitted, the knockout plug in the disposer's dishwasher inlet may not have been removed during installation.

Technical notes

What LG repairs involve

Our technicians handle LG refrigerators with linear compressors, freezers, Direct Drive washers and dryers, along with LG dishwashers, ovens, ranges, stoves, cooktops and microwaves.

An LG washer has no belt to wear out, because its Direct Drive motor is mounted on the drum itself; age shows instead in the rotor, stator and bearings, typically as noise or visible drum play during a heavy spin. A number of current LG models support Smart Diagnosis, which sends a diagnostic tone or data through the LG ThinQ app so the owner and LG can read the result; it is worth running before you book, and sharing the result with us when you call. The LG linear compressor drives its piston directly, with no crankshaft in between; that design runs quietly and efficiently, and it requires a sealed-system test procedure different from the one used on a conventional reciprocating compressor.

Garage refrigerators and freezers

A freezer kept in a garage in Greater Houston can lose its contents without any visible warning. No fault code is shown and no alarm sounds, and the problem is frequently discovered only after food has thawed and refrozen.

For any refrigerator or freezer kept in a garage or a utility room without air conditioning, we recommend an inexpensive thermometer with a remote alert, which will report a rise in temperature while the contents can still be saved. It also tells you after a power outage whether the unit came back on. If the appliance proves to be genuinely defective, our technicians will repair it, though the surrounding temperature is often the entire explanation.

Questions

Questions about LG repair

What does the IE code on an LG washer indicate?

The washer did not fill within the expected time. Check the supply tap, the inlet screens and the water inlet valve.

What does the OE code on an LG washer indicate?

The washer cannot drain. Inspect the pump filter first, then the drain hose, and finally the drain pump itself.

What does the UE code on an LG washer indicate?

The washer was unable to redistribute an unbalanced load.

Arrange LG service

If your LG supports Smart Diagnosis, run it in the LG ThinQ app before you call and read us the result with the model number.

Call, any hour(832) 476-8009Book on the web